The hooks are the most common issue concerning sewing machine’s timing. The second most common issue is related to the needle. The first step is to check the sewing machine’s timing to make sure that there is a problem.
The first step is to check the direction of the rotation of the hook.
If the hook is turning clockwise, the needle must be moved to the far right.
If the hook is turning counter-clockwise, the needle must be moved to the far left. Embroidery Sewing Machine Repair Center in Chennai
The next step is to look at the tip of the hook as it rotates. Is the hook passing through or underneath the eye of the needle? If it is going underneath the eye then the timing is considered “off.” If the hook is passing above the eye this could be indicative of a timing issue also.
This is one of the common sewing machine problems that sewist faces every once in a while. Once you know that you need to make an adjustment, make sure that your sewing machine is set to straight stitch. Remove the machine’s base cover if you haven’t yet done so. You’d also have the following tools:
Small flathead screwdriver
Flashlight or lamp
Ruler or Tape Measure
Sewing Machine Oil
Marker
If the markings aren’t present, the needle will need to be lowered completely with the hand wheel. Raise your needle 2.4 millimeters and then adjust the needle so that it is 2.4 millimeters below the point of the hook. We recommend adding markings to your sewing machine to make this easier if it needs to be done again. Overlock Sewing Machine Repair Center in Chennai
The next step in making your timing adjustment for the hook. This process varies among machines, but there are general directions. We recommend consulting your owner’s manual to make sure that there are no model specific alterations to these general directions.
Use the hand wheel to lower the needle bar as low as possible and loosen the gears in the base.
Make the adjustment until the needle and hook are at the correct distance.
Depending on your unique sewing machine, this distance can range anywhere from 0.04 millimeters to 0.1 millimeters.
Comments